:	Jul 14, 2004

:

The seal installation tools are available individually or as a set 303-S524

.

Disconnect the battery ground cable.

.

: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands. Raise and support the vehicle.

.

Remove the torque converter flexplate.

.

Remove the closing plate.

.

: Care must be taken to avoid damage to the seal register and running surface. Using the special tools, remove and discard the crankshaft rear oil seal.

.

Install the special tool, 303-527.   Make sure the components are clean and dry.   Tighten the 2 Allen screws.

.

: Make sure the seal is installed parallel Using the special tool, install the crankshaft rear oil seal.   Lubricate the seal with clean engine oil.   Partially install the crankshaft rear oil seal.   Tighten the bolt to fully install the seal.

.

Install the closing plate.   Clean the components.

.

Install the torque converter flexplate.

.

Connect the battery ground cable.

.

Check and top-up the engine oil.